Print Shortlink

Formula one in the making

Formula one in the making:

Car:
Maximum width: 190mm
Minimum weight = 1050 grams including personal transponder
Minimum ride height = 4mm
– Front independent king pin, coil spring suspension is allowed. Suspension pick up points must be mounted inside the body. Independent front shocks are not allowed.
– The main chassis plate must not protrude from the body when viewed from above

Tires:
Front: Rubber Spec tires supplied at the event TBA
Rear: Rubber Spec tires supplied at the event TBA
Additive:
Only ONE special additive is allowed which will be supplied at the event and can only be applied in the designated tire saucing area.

Bodies:
Only post 2009 Formula 1 body styles are allowed. Body must be painted in a race inspired theme. Single color themes are allowed but you must use the included sticker sheet to detail the car.
All cars must have a realistic drivers figure installed in the cockpit.

F1 Wings:
Only non-Lexan front and rear wings of injection molded plastic front and rear wings can be used
No front wing shall overhang 190mm and rear wings must not be wider than inside of the rear wheels
Further details to be advised

Batteries:
Any IFMAR approved 2S LIPO charged in a special LIPO bag may be used
Maximum battery voltage: 8.4 volts

Motor:
SPEC 21.5 ( 25.5?) fixed timing motors. No modifications allowed

Note THESE RULES NEED TO BE COMPLETED.

Frank Mostrey